DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 060 工学部・工学研究科 > 060 学術雑誌論文 >

Separation of PRMMC into matrix alloy and reinforcements by nozzle filtering method

ファイル 記述 サイズフォーマット
JMPT209_4264.pdf550.62 kBAdobe PDF本文ファイル

タイトル: Separation of PRMMC into matrix alloy and reinforcements by nozzle filtering method
著者: Mizumoto, Masayuki / Ohgai, Takeshi / Kagawa, Akio
発行日: 2009年 5月 1日
出版者: Elsevier B.V.
引用: Journal of Materials Processing Technology, 209(9), pp.4264-4267; 2009
抄録: The SiCP/Al–4 mass%Cu alloy composites fabricated by a low-pressure infiltration process (LPI process) were remelted and separated by nozzle filtering method. In the separation process, the PRMMC specimen was placed in a container with a small nozzle at the bottom. The molten PRMMC was forced to flow out through the nozzle by applying a certain pressure of Ar gas. Most of the molten matrix alloy flowed out through the nozzle and the remainder in the container consisted of SiC particles and a part of the matrix alloy. The particle volume fraction of the remainder was higher than that of the original PRMMC and the remainder would work as a filter to separate SiC particles from the matrix alloy melt. When nozzle tip angle was ranged from 60° to 120°, about 80% of matrix alloy in the PRMMC was separated and few SiC particles were observed in the separated matrix alloy. The surface of recovered SiC particles became slightly roughened due to the reaction with the molten matrix during the separation process. However, this is not expected to affect their reuse.
キーワード: Metal matrix composite / Recycling / Separation technique / Filtering
URI: http://hdl.handle.net/10069/21902
ISSN: 09240136
DOI: 10.1016/j.jmatprotec.2008.11.006
権利: Copyright © 2008 Elsevier B.V. All rights reserved.
資料タイプ: Journal Article
原稿種類: author
出現コレクション:060 学術雑誌論文

引用URI : http://hdl.handle.net/10069/21902



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace