DSpace university logo mark
Advanced Search
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > Faculty of Engineering > Bulletin > Reports of the Faculty of Engineering, Nagasaki University > No.5 >


File Description SizeFormat
kogaku00_05_12.pdf392.2 kBAdobe PDFView/Open

Title: 製作費を考慮したI型ばりのSUMT法による最適設計について
Other Titles: Optimum Design by SUMT Method Including Fabrication Cost for I-Section Girders.
Authors: 小西, 保則
Authors (alternative): Konishi, Yasunori
Issue Date: Dec-1974
Publisher: 長崎大学工学部 / Faculty of Engineering, Nagasaki University
Citation: 長崎大学工学部研究報告, (5), pp.89-94; 1974
Abstract: The optimum design for I-section girders is the most fundamental approach of their various designs and a great n umber of study on it have been reported but the study on a design method including fabrication cost has litt1e been reported. The present paper is intended for a study on the optimum design including fabrication cost. In this report the optimum design is investigated by the SUMT method (the sequence of unconstrained minimization technique) for I-section girders with one cover plate on either upper or lower flange with a comparison with SLP method (the sequence of linear programing method) which is one of the other non-linear programings, under the assumption that cover plate thickness. flange plate thickness, web plate high and length of cover plate from the center line of the girder are variables, and cover plate width, flange plate width and web plate thickness are constants. The results of calculation by the SUMT method differ from the results by the SLP method in the variables, and the values of z do not differ so much.
URI: http://hdl.handle.net/10069/23823
ISSN: 02860902
Type: Departmental Bulletin Paper
Text Version: publisher
Appears in Collections:No.5

Citable URI : http://hdl.handle.net/10069/23823

All items in NAOSITE are protected by copyright, with all rights reserved.


Valid XHTML 1.0! Copyright © 2006-2015 Nagasaki University Library - Feedback Powerd by DSpace