DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 060 工学部・工学研究科 > 060 紀要 > 長崎大学工学部研究報告 > 第21巻 第37号 >


ファイル 記述 サイズフォーマット
kogaku21_37_04.pdf476.04 kBAdobe PDF本文ファイル

タイトル: プラスチック歯車の動力伝達時歯面温度分布の計測
その他のタイトル: Measurement of Temperature Distributions on Plastic Gear Tooth Flanks Transmitting Power
著者: 西田, 知照 / 扇谷, 保彦 / 小林, 洋一
著者(別表記) : Nishida, Noriteru / Ougiya, Yasuhiko / Kobayashi, Youichi
発行日: 1991年 7月
出版者: 長崎大学工学部 / Faculty of Engineering, Nagasaki University
引用: 長崎大学工学部研究報告, 21(37), pp.119-124; 1991
抄録: In regard to plastic gears which are used for power transmission, their tooth temperatures have been thought as the most important factor. Because tooth temperature have a great influence on tooth stiffness, brakage, wear, vibration and so on. In this study, the temperature distributions on tooth flanks are measured by a radiation pyrometer. From 40 to 56 points per one tooth flank are selected as measuring points. By using the temperature data got from these measuring points, temperature distribution maps on tooth flanks are drawn. Steel drivers and plastic followers are engaged. Their pitch diameters are 135 mm and modules are 3 and 5. Under running conditions of 300 rpm to 1200 rpm and 19.6 Nm to 78.4 Nm, the following are resulted: (1) Tooth flank temperatures in module 3 are lower than that in module 5. (2) In constant-power transmission, tooth flank temperatures in a combination of high-speed and low-torque are lower than that in a combination of low-speed and high-torque.
URI: http://hdl.handle.net/10069/24341
ISSN: 02860902
資料タイプ: Departmental Bulletin Paper
原稿種類: publisher
出現コレクション:第21巻 第37号

引用URI : http://hdl.handle.net/10069/24341



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace