DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 060 工学部・工学研究科 > 060 紀要 > 長崎大学工学部研究報告 > 第23巻 第40号 >


ファイル 記述 サイズフォーマット
kogaku23_40_08.pdf657.56 kBAdobe PDF本文ファイル

タイトル: 線状加熱による鋼板の変形に関する予備的考察
その他のタイトル: A Preliminary Study on the Angular Distortion by Line-Heating
著者: 中島, 正樹 / 河野, 和芳 / 勝田, 順一
著者(別表記) : Nakajima, Masaki / Kawano, Kazuyoshi / Katsuta, Jyunichi
発行日: 1993年 1月
出版者: 長崎大学工学部 / Faculty of Engineering, Nagasaki University
引用: 長崎大学工学部研究報告, 23(40), pp.55-64; 1993
抄録: The line-heating process by oxy-acetylene gas flame is extensively applied to the bending of thicksteel plates in fabrication of steel structures. But it is one of the difficult manufacturing techniques in the ship-building industry. In order to solve the technical problems in plate-bending process, a lot of investigations were conducted in the past 30 years in Japan. Although their results have been reported many papers concerning line-heating method, there are many problems remaining unsolved and is not used enough yet in automatic and efficient process of ship-hull plate-bending. The authors carried out the preliminary experiments on the effects of line-heating for the efficient method of plate-bending. The purpose of this study is to find a relation between several heating conditions and induced angular distortions. In this investigation the following facts were clarified; 1) It is necessary to consider the heating breadth for calculation of angular distortion. 2) Angular distortion is influenced by not only the difference of peak temperatures at heating sufrace and back surface but also the value of peak temperature at heating surface. 3) Angular distortion is affected considerably by the pre-heating due to heat conduction.
URI: http://hdl.handle.net/10069/24394
ISSN: 02860902
資料タイプ: Departmental Bulletin Paper
原稿種類: publisher
出現コレクション:第23巻 第40号

引用URI : http://hdl.handle.net/10069/24394



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace