DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 060 工学部・工学研究科 > 060 学術雑誌論文 >

Magnetic properties of pulsed laser deposition-fabricated isotropic Fe–Pt film magnets

ファイル 記述 サイズフォーマット
JAP109_07A723.pdf387.11 kBAdobe PDF本文ファイル

タイトル: Magnetic properties of pulsed laser deposition-fabricated isotropic Fe–Pt film magnets
著者: Nakano, Masaki / Oniki, W. / Yanai, Takeshi / Fukunaga, Hirotoshi
発行日: 2011年 4月 1日
出版者: American Institute of Physics
引用: Journal of Applied Physics, 109(7), 07A723; 2011
抄録: A high-speed pulsed laser deposition method with the deposition rate of several tens of microns per 1 h enabled us to obtain isotropic Fe-Pt thick film magnets. Increase in the laser power enabled us to obtain as-deposited films with L10 ordered phase due to the heat radiation from a target, which means that a substrate heating system and a post-annealing process are not required to achieve hard magnetic properties in the process. Use of an Fe-rich target enhanced the magnetic properties, and as a result (BH)max value exceeded 100 kJ/m3 in an isotropic Fe-Pt film fabricated at the power of 3 W, which was comparable to those of isotropic Fe-Pt thick film magnets prepared by a sputtering method.
URI: http://hdl.handle.net/10069/25446
ISSN: 00218979 / 10897550
DOI: 10.1063/1.3561785
権利: © 2011 American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics.The following article appeared in [Journal of Applied Physics, 109(7), 07A723; 2011] and may be found at http://dx.doi.org/10.1063/1.3561785.
資料タイプ: Journal Article
原稿種類: publisher
出現コレクション:060 学術雑誌論文

引用URI : http://hdl.handle.net/10069/25446



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace