DSpace university logo mark
Advanced Search
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > Faculty of Education > Bulletin > Science bulletin of the Faculty of Education, Nagasaki University > No. 45 >

木材切削における被削材面に現れる節の切削に関する基礎的研究-2 : 木材の三次元縦切削における切削力の変化に及ぼす被削材面に現れる丸小節の影響


File Description SizeFormat
kyoikuS45_095.pdf5.07 MBAdobe PDFView/Open

Title: 木材切削における被削材面に現れる節の切削に関する基礎的研究-2 : 木材の三次元縦切削における切削力の変化に及ぼす被削材面に現れる丸小節の影響
Other Titles: Fundamental Studies on Cutting of the Knot on the Cutting Surface of the Workpiece in Wood Cutting (II) Effects of the Small Round Knot on the Cutting Surface of the Workpiece upon the Cutting Force in Oblique Cutting of Wood Parallel to the Grain
Authors: 杉山, 滋
Authors (alternative): Sugiyama, Shigeru
Issue Date: 31-May-1991
Publisher: 長崎大学教育学部
Citation: 長崎大学教育学部自然科学研究報告. vol.45, p.95-110; 1991
Abstract: In the wood cutting process with a knife equipped with a chip breaker for making the smooth workpiece-surface, it is important to obtain the optimum conditions of sharpness angle of the chip breaker (βB), the distance between the knife edge and the chip breaker edge (ℓK-B) and the inclination angle of the knife (ik) and to investigate the changes of the cutting-force components acting on the face of a knife equipped with a chip braker with βB, ℓK-B, ik, the grain angle of the workpiece (φ1) and the knot on the cutting surface of the workpiece. In order to obtain quantitative information on them, the basic oblique cutting tests, in which the materials used were air-dried wood boards of hinoki (Chamaedyparis obtusa ENDLICHER) and sugi (Cryptomeria japonica D.Don), were pergormed using the knife as shown in Figs. 2~3 and the same experimental apparatus as used in the previous reports. The test specimens, which were fixed to the experimental apparatus equipped with a three-dimensional elasticring dynamoneter, were cut during the feeding of the knife equipped with a chip breaker (Figs. 3~6).The components and the resultant force were measured.Using these results, the effects of ik and the workpice clarified (Figs.7(a)~8(b)). Characteristics of the cutting of the knot on the workpiece surface are discussed, comparing the cutting of the workpiece without a knot.
URI: http://hdl.handle.net/10069/32317
ISSN: 0386443X
Type: Departmental Bulletin Paper
Text Version: publisher
Appears in Collections:No. 45

Citable URI : http://hdl.handle.net/10069/32317

All items in NAOSITE are protected by copyright, with all rights reserved.

 

Valid XHTML 1.0! Copyright © 2006-2015 Nagasaki University Library - Feedback Powerd by DSpace