DSpace university logo mark
Advanced Search
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > Faculty of Education > Bulletin > Science bulletin of the Faculty of Education, Nagasaki University > No. 45 >

木材切削工具の切れ味測定と切れ味評価-8 : 裏金を装着した直刃状鉋刃による木材の三次元切削における鉋刃傾斜角および被削材繊維傾斜角の影響


File Description SizeFormat
kyoikuS45_135.pdf9.48 MBAdobe PDFView/Open

Title: 木材切削工具の切れ味測定と切れ味評価-8 : 裏金を装着した直刃状鉋刃による木材の三次元切削における鉋刃傾斜角および被削材繊維傾斜角の影響
Other Titles: Studies on Quantification of Sensuous Sharpness and Mechanical Sharpness of Wood Cutting Tools. VIII. Effects of Inclination Angle of the Knife and Grain Angle of the Workpiece upon Variation of Cutting Force in Oblique Cutting of Wood Parallel to the Grain with the Knife Equipped with a Chip Breaker
Authors: 杉山, 滋
Authors (alternative): Sugiyama, Shigeru
Issue Date: 31-May-1991
Publisher: 長崎大学教育学部
Citation: 長崎大学教育学部自然科学研究報告. vol.45, p.135-164; 1991
Abstract: The purpose of this report is to clarify the effects of the inclination angle (i(k)) of the knife, the distance (ℓ(k)) on the knife rake-face from the knife edge to the chip-breaker edge, and the grain angle (φ) of the workpiece upon the variations of the components and the resultant of the cutting force in the oblique cutting of wood parallel to the grain with the knife equipped with a chip breaker. Air-dried specimens of Douglas fir (Pseudotsuga menziesii) were used in this study, and were cut by feeding a knife equipped with a chip breaker, which was set on the same experimental apparatus equipped with a three-dimensional elastic-ring dynamometer as used in the previous reports4)~6). The lateral (FX), main (FY), and thrust (FZ) components of the cutting force acting on the knife equipped with the fhip breaker were measured. Using the measured components mensioned above, the resultant (R) was calculated. Based on these results, effects of the cutting conditions (i(k) and ℓ(k)) and the workpiece condition (φ) upon the variations of the components and the resultant of the cutting force were clarified (Figs. 15~22). Characteristics of the oblique wood-cutting with a chip breaker are discussed, comparing its cutting with the oblique wood-cutting without a chip breaker and the orthogonal wood-cutting.
URI: http://hdl.handle.net/10069/32319
ISSN: 0386443X
Type: Departmental Bulletin Paper
Text Version: publisher
Appears in Collections:No. 45

Citable URI : http://hdl.handle.net/10069/32319

All items in NAOSITE are protected by copyright, with all rights reserved.

 

Valid XHTML 1.0! Copyright © 2006-2015 Nagasaki University Library - Feedback Powerd by DSpace