DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 010 教育学部・教育学研究科 > 010 紀要 > 長崎大学教育学部紀要. 自然科学 > 第64号 >

木材切削工具の切れ味測定と切れ味評価 (XXI) : 裏刃を装着した工具による木材切削における工具切れ刃面および裏刃すくい面に加わる切削抵抗の変動

ファイル 記述 サイズフォーマット
KJ00000045809.pdf575.62 kBAdobe PDF本文ファイル

タイトル: 木材切削工具の切れ味測定と切れ味評価 (XXI) : 裏刃を装着した工具による木材切削における工具切れ刃面および裏刃すくい面に加わる切削抵抗の変動
その他のタイトル: Studies on Quantification of Sensuous Sharpness and Mechanical Sharpness of Wood Cutting Tools. XXI : Cutting Forces acting on Tool Face and on Chip Breaker Face in Wood Cutting with Tool equipped with a Chip Breaker
著者: 杉山, 滋
著者(別表記) : Sugiyama, Shigeru
発行日: 2001年 3月28日
引用: 長崎大学教育学部紀要. 教育科学. vol.68, p.27-41; 2005 / 長崎大学教育学部紀要. 自然科学. vol.64, p.27-33; 2001
抄録: In the wood cutting process with a tool equipped with a chip breaker, it is important to obtain the optimum conditions of sharpness angle of the chip breaker (β') and distance between tool edge and chip breaker edge (l_c) and to investigate the changes of cutting forces acting on a tool face and on a chip breaker face with β', l_c and grain angle (φ_1)(Fig.1). In order to obtain quantitative information on them, the basic orthogonal cutting tests were performed using the conventional tool and the same composite tool as used in the previous reports. The results obtained are as follows : (1) Although the cutting force acting on the chip breaker face changes with β' and l_c, it does so remarkably under the combination of larger angle of β' and smaller value of l_c. As compared with this, the cutting force acting on the tool face slightly varies with β' and l_c (Figs.2∿5). (2) The variation of the total cutting force acting on the tool equipped with a chip breaker with φ_1 decreases not only with increase in β' but also with decrease in l_c (Fig.6).
URI: http://hdl.handle.net/10069/6091
ISSN: 13451359
資料タイプ: Departmental Bulletin Paper

引用URI : http://hdl.handle.net/10069/6091



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace