DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 010 教育学部・教育学研究科 > 010 紀要 > 長崎大学教育学部紀要. 自然科学 > 第67号 >

単板剥ぎ取り機械に関する研究(XXII) : 単板切削におけるナイフすくい面に働く摩擦挙動に及ぼすプレッシャバー作用の影響

ファイル 記述 サイズフォーマット
KJ00000045849.pdf533.02 kBAdobe PDF本文ファイル

タイトル: 単板剥ぎ取り機械に関する研究(XXII) : 単板切削におけるナイフすくい面に働く摩擦挙動に及ぼすプレッシャバー作用の影響
その他のタイトル: Studies on Veneer Cutting Machine XXII Effects of Pressure Bar Compression upon Frictional Behavior on Interface between Tool and Chip in Veneer Cutting
著者: 杉山, 滋
著者(別表記) : Sugiyama, Shigeru
発行日: 2002年 6月28日
引用: 長崎大学教育学部紀要. 自然科学. vol.67, p.45-51; 2002
抄録: In the present paper, the stress distribution and the frictional coefficient on the interface between the tool and the chip in the veneer cutting with the sharp bar were made clear, using the composite tool which was divided into two parts. The results obtained are summarized as follows : (1) The frictional coefficient (μ) in veneer cutting can be derived approximately from the frictional theory, as shown in Fig. 1 and expressed by Eqs.(1) ∿ (9), and be expressed by Eq.(10). (2) The frictional coefficient (μ) on the interface between the tool and the chip under the sharp bar compression can be considered to be constant. μ decreases as the depth of cut (t) increases, and is smaller with air-dried workpieces than with watersaturated ones. But μ is smaller in the veneer cutting with the sharp bar than without a pressure bar (Table 2). (3) As the horizontal opening (H) decreases, both normal stress (σ) and frictional stress (τ) increase, but the increasing tendency of σ is more remarkable than that of τ. On the basis of the change of these stress distributions with the change of H, μ can be considered to show a decreasing tendency as H decreases (Table 3).
URI: http://hdl.handle.net/10069/6115
ISSN: 13451359
資料タイプ: Departmental Bulletin Paper

引用URI : http://hdl.handle.net/10069/6115



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace