DSpace university logo mark
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > 010 教育学部・教育学研究科 > 010 紀要 > 長崎大学教育学部紀要. 自然科学 > 第73号 >

単板剥ぎ取り機械に関する研究(XXX) : 単板の三次元横切削における切削力の変化に及ぼすバイアス角の影響

ファイル 記述 サイズフォーマット
KJ00004167765.pdf445.08 kBAdobe PDF本文ファイル

タイトル: 単板剥ぎ取り機械に関する研究(XXX) : 単板の三次元横切削における切削力の変化に及ぼすバイアス角の影響
その他のタイトル: Studies on Veneer Cutting Machine (XXX) : Effect of Tool Inclination - Angle on Cutting Force in the Oblique Veneer Cutting of Wood Perpendicular to the Grain
著者: 杉山, 滋
著者(別表記) : Sugiyama, Shigeru
発行日: 2005年 6月30日
引用: 長崎大学教育学部紀要. 自然科学. vol.73, p.29-34; 2005
抄録: This report clarifies the effects of the tool inclination-angle (I) and the grain orientation of the workpiece upon the components and two kinds of the resultant of the cutting force and the frictional coefficient in the oblique cutting of wood perpendicular to the grain. Air-dried specimens of sugi (Cryptomeria japonica) and shirakashi (Quercus myrsinaefolia) were used in this study. Specimens were cut by feeding a tool which was set on the same experimental apparatus equipped with a three-dimensional elastic-ring dynamometer as used in a previous reports. The lateral (F_x), main (F_Y), and thrust (F_Z) components of the cutting force acting on the tool were measured. In addition, the conditions of the cutting surfaces of the workpiece were observed and estimated. Using the measured components, the resultants (R and R_C) and the frictional coefficient (μ) on the tool rake - face were calculated. Then, the effects of the cutting conditions (I) , the depth of cut (t_n) and the workpiece conditions (wood species and grain orientation) upon them, and the relationship of μ to the conditions of the cutting surfaces of the workpiece are discussed.
URI: http://hdl.handle.net/10069/6147
ISSN: 13451359
資料タイプ: Departmental Bulletin Paper

引用URI : http://hdl.handle.net/10069/6147



Valid XHTML 1.0! Copyright © 2006-2015 長崎大学附属図書館 - お問い合わせ Powerd by DSpace