DSpace university logo mark
Advanced Search
Japanese | English 

NAOSITE : Nagasaki University's Academic Output SITE > Faculty of Education > Bulletin > Science bulletin of the Faculty of Education, Nagasaki University > No. 59 >

単板剥ぎ取り機械に関する研究 (VI) : 工具すくい面に働く切削応力の分布


File Description SizeFormat
KJ00000136355.pdf386.7 kBAdobe PDFView/Open

Title: 単板剥ぎ取り機械に関する研究 (VI) : 工具すくい面に働く切削応力の分布
Other Titles: Studies on Venner Cutting Machine (VI) : Cutting Stress Distribution on Tool Rake Face
Authors: 杉山, 滋
Authors (alternative): Sugiyama, Shigeru
Issue Date: Jun-1998
Citation: 長崎大学教育学部自然科学研究報告. vol.59, p.25-30; 1998
Abstract: In the veneer cutting process, it is important to obtain the actual cutting stress distributions on the interface between the tool and the veneer during cutting, and to investigate the changes of the cutting stress behavior depending on the workpiece conditions and cutting conditions, but few studies have dealt with the exact measurements of the cutting stress distributions. The main objective of this paper is to obtain quantitative information on them. The method of measurement was based on the use of a composite tool which was divided into two parts parallel to a cutting edge in order to measure separately the force on one section of the tool. Using this tool, the stress distribution on a rake face was measured directly in the veneer cutting without a pressure bar.
URI: http://hdl.handle.net/10069/6188
ISSN: 0386443X
Type: Departmental Bulletin Paper
Appears in Collections:No. 59

Citable URI : http://hdl.handle.net/10069/6188

All items in NAOSITE are protected by copyright, with all rights reserved.

 

Valid XHTML 1.0! Copyright © 2006-2015 Nagasaki University Library - Feedback Powerd by DSpace